7
8
ST31 LT STEM
Cervélo ST31 LT Stem
(Carbon)
Rubber Plug
for ST32
Top Cap
PL-338
Preload Fixing
Screw
M6 x 25
ST32 Stem
Top Cap
80mm ST-C031L-80
90mm ST-C031L-90
100mm ST-C031L-100
110mm ST-C031L-110
120mm ST-C031L-120
130mm ST-C031L-130
Only use the components specified in this manual
for handlebar and stem assembly. Failure to use
the specified parts and to follow the supplied
assembly instructions may result in a loss of
control while riding and serious injury.
Do not flip
ST31 LT
stem for
additional
stack.
ST31 LT Accessory Mount
Assembly MT-521A. See
page 10 for assembly
instructions.
ST31 LT faceplate insert
is removable for use with
the compatible Accessory
Mount Assembly.
Tighten fork
steerer fixing
screws to 5Nm.
Tighten stem
faceplate fixing
screws to 6Nm.
FRAME & COMPONENT PREPARATION
Hold the frame using a secured seatpost only.
Clamping the top tube can damage the frame
and void your warranty.
If trimming of the seatpost is
required, final length should
allow for a minimum of 70mm
of seatpost remaining in the
frame, or the minimum insertion
dimension indicated on the
seatpost, whichever is greater.
Failure to meet this requirement,
may result in damage to the
frame not covered by warranty
policy, or serious injury to rider.
1. Apply carbon paste to the frame
and seatpost shaft to be inserted
into the frame.
2. Insert the seatpost and the
assembled Seatpost Clamp &
Cover (SPC-0H0R5) into the
frame.
3. Adjust height and torque
the Seatpost Clamp to 8Nm
maximum.
Generously
grease all
internal
surfaces of
the Seatpost
Clamp.
Press fit
Cover over
the Seatpost
Clamp prior to
installing in
the frame.
Use a 3mm allen key
to lift cover and
access fixing screw of
the Seatpost Clamp as
highlighted.
NOTE:
Non-use
of the Cover
may result
in seatpost
binding due to
accumulated
debris.
