Preparation of remote control
Remove plastic insulating sheet located at the bottom of remote control.
Replacement Battery Installation
Remove the battery compartment cover by sliding the cover. Pull out the cover.
Insert the battery with the polarity “+” facing up.
Replace the cover.
CAUTION
• Use only a 3V lithium battery (CR2025).
• Ensure that you have the batteries’ polarity (+/−) aligned correctly.
• If the remote control gets wet, wipe it dry immediately.
• Avoid excessive heat and humidity.
• Do not short, heat, or disassemble batteries.
• Do not throw batteries into a fire.
• If you will not be using the remote control for a long time, remove the batteries.
• Dispose of used batteries according to your local regulations.
• Children may ingest small batteries; always keep batteries safe and out of reach of children and pets. WARNING: If a
battery is swallowed, consult a doctor immediately as this could result in asphyxiation or be an obstacle to digestion,
etc.
Remote control operating range
The remote control uses infrared transmission to control the PentaClass. It is necessary to point the remote directly at
the PentaClass. The remote will function well within a radius of about 7 meters (23 feet) and within a 140 degree angle
from the PentaClass IR sensor location level. If the PentaClass does not respond to the remote control, move it a little
closer.
The Runa Microphone
Your Runa Microphone components and button commands
Infrared Transmitter
Power ON/OFF
Hold Power ON/OFF button for a 3 seconds
-
Pairs microphone with already paired PentaClasss speaker
Hold Power ON/OFF button for a 10 seconds
-
Pairs microphone with a new, (non paired), PentaClasss speaker
Arrow Button 1
Arrow Button 2
LED Indication light
Micro USB charging slot
2.5mm output for the optional external over-the-ear microphone
Hold Volume up button together with Power ON/OFF button for 3 seconds
- Bluetooth channel activates.
Hold Volume down button together with Power ON/OFF button for 3 seconds
- AUX channel ON/OFF activates.
Preparing Your Runa Microphone
Take the microphone from the packaging and charge it before using it for the first time - the charging procedure is
described in the next paragraph.
Charging your Runa Microphone Battery
CHARGING PROCEDURE FOR MICROPHONE UNIT
Before using it for the first time, the microphone should be charged accordingly:
• Connect one end of the USB cable to the Micro USB charging slot and connect the other end of the USB cable to the
USB charger or your computer.
• If the USB charger is used, connect it to a 100-240V power supply outlet.
A fully charged microphone will last up to 7 hours of use. If microphones are used daily, they should be charged
frequently.
It will take up to 3-4 hours for the microphone to obtain a full charge.
MICROPHONE STATUS INDICATION WHILE IT’S CHARGING
•
Steady orange
- microphone is charging
•
Steady green
- microphone is fully charged
MICROPHONE STATUS INDICATION WHILE IT’S PAIRED TO THE PENTACLASS
•
Blinking green
- microphone is paired to the PentaClass
•
Blinking red
- microphone is paired to the PentaClass, but the battery is running out and it will last up to 30 minutes
• No status indication - microphone is disconnected from the PentaClass, (is not paired), or the Battery has fully
discharged
1
2
1
2
3
1
2
3
3
4
5
6
7
1
2
3
4
5
6
7
Certes PentaClass Operating Manual
13
