Installation Guide for FibeAir IP-20S, FibeAir IP-20S Assured
Page 57 of 105
Ceragon Proprietary and Confidential
4.2
PoE Injector Grounding
To ground the PoE Injector:
1 On the right side of each PoE Injector, loosen the screw, plain washer, and
serrated washer.
2 Place the cable lug (supplied with the PoE injector kit) between the plain and
serrated washer.
3 Tighten the screw.
4 Perform a resistance test between the 2 lugs of the GND cable. Verify that the
result is 0-2 ohms.
4.3
PoE Injector Wall Mount Installation
List of Items
Item
Description
Quantity Remarks
1
PoE Injector
1
1
Glands Kit
1
For outdoor installations.
Note:
Glands are required for outdoor installations. The glands kit (three or
five glands) is not supplied with the PoE Injector, and must be ordered
separately.
Glands Kit
Marketing Model
Marketing Description
IP-20_3xGlands_kit
IP-20_3xGlands_kit
IP-20_Glands_kit
IP-20_Glands_x5_kit
Required Tools
•
Metric offset wrench key wrench set
•
Hammer
•
Drilling Machine
Procedure
1 Mount and tighten the PoE Injector to a wall using two M6 bolts and anchors.
The M6 bolts and anchors must be purchased separately.
Note:
Use Anchor Stainless Steel with flanged Hexagonal nut M6X70.
2 Drill two 6mm diameter holes with 100mm distance between the center of
the holes.
3 Insert the anchors with the bolts.
