Ceragon FibeAir IP-20C, User Manual

Page: 33 / 597

FibeAir IP-20C/S/E User Guide
Ceragon Proprietary and Confidential Page 33 of 597
2.
Getting Started
This section includes:

Assigning IP Addresses in the Network

Establishing a Connection

Logging on

Changing Your Password

Configuring In-Band Management

Changing the Management IP Address

Configuring the Activation Key

Setting the Time and Date (Optional)

Enabling the Interfaces (Interface Manager)

Configuring the Radio Parameters
 Configuring the Radio (MRMC) Script(s)

Enabling ACM with Adaptive Transmit Power

Operating in FIPS Mode

Configuring Grouping (Optional)
 Creating Service(s) for Traffic
2.1
Assigning IP Addresses in the Network
Before connection over the radio hop is established, it is of high importance
that you assign the IP-20 unit a dedicated IP address, according to an IP plan
for the total network. See Changing the Management IP Address.
By default, a new IP-20 unit has the following IP settings:

IP address: 192.168.1.1
 Subnet mask: 255.255.255.0
Warning! If the connection over the link is established with identical
IP addresses, an IP address conflict will occur and the
remote connection may be lost.
2.2
Establishing a Connection
Connect the IP-20 unit to a PC by means of a TP cable. The cable is connected
to the MGT port on the IP-20 and to the LAN port on the PC. Refer to the
Installation Guide for the type of unit you are connecting for cable connection
instructions.