FibeAir IP-20C/S/E
User Guide
Ceragon Proprietary and Confidential
Page 47 of 597
2.10
Configuring the Radio Parameters
In order to establish a radio link, you must:
Unmute the radio carrier.
Configure the radio frequencies.
Configure the TX level.
You can do these tasks, perform other radio configuration tasks, and display
the radio parameters in the Radio Parameters page.
To configure the radio parameters:
1 Select Radio > Radio Parameters. The Radio Parameters page opens.
For IP-20C units, the Radio Parameters page initially displays a table as
shown in Figure 16.
For IP-20S units and IP-20E units, a page appears, similar to Figure 17
(which shows an IP-20C page).
Figure 16: Radio Parameters Page
– IP-20C
2 For IP-20C units, select the carrier in the Radio table (see Figure 16) and
click Edit. A separate Radio Parameters page opens. The page is essentially
identical to the IP-20E and IP-20S page, except for the addition of a Radio
location parameter.
