Installation
4.3 Front door opening procedure for
HPe2/4CM
The electric heater door can be opened very easily in a few
steps.
Remove the key that is attached to the front door lock.
Insert the key into the lock.
Turn the key to the lock (unlock).
Gently pull the handle towards you.
Turn the handle to the right and the electric heater door
will open.
4.4 WALL MOUNTING HPe2/4CM
NOTE:
Material damage occurred by irregular
installation on the wall!
It is necessary to use proper material for fixing
This chapter describes mounting the HPe2/4CM on a wall.
Plot the drill hole positions for the mounting kit
respecting the minimum free space dimensions next to
the HPe2/4CM (Image 3) and the dimensions in Table 5.
Drill the holes according to the dimensions for the given
type of HPe2/4CM.
Insert plastic dowels that are part of the device
packaging (or dowels adequate for a non-standard wall
type) into the drilled holes.
Then fasten the bracket with the screws supplied with
the dowels.
Carefully hang the device on the wall
Make sure the HPe2/4CM is upright.
Take care of the correct position during installation