GB
Cleaning battifiamma
The thermostove is provided with two elements in vermiculite:
the bottom of the combustion chamber and the battifiamma.
Vermiculite is a mineral from a variety of uses in industry
and construction for its insulating properties, thermal
and acoustic properties. In this case, the vermiculite is
used to avoid unnecessary heat dispersions. Because
of its fragility, it is recommended to handle with extreme
care battifiamma during the cleaning of the combustion
chamber and clean it only with a soft, dry cloth.
Shutting the thermostove down
In the period when the thermostove is out of use it
must be disconnected from the electricity mains. For
greater safety, especially if there are children around, we
recommend removing the power cable from the rear of the
thermostove.
Before placing the thermostove in storage, you should
remove all pellets from the hopper with a vacuum cleaner
with a long extension. If the fuel is left in the hopper, it may
get damp, stick together, and be difficult to light at the
beginning of the next season.
If pressing the main switch (located on the back of the
stove) does not make the control panel display light up, it
could mean that the service fuse needs replacing.
On the rear of the stove there is a fuse holding
compartment which is located underneath the supply
socket. With a screwdriver open the cover of the fuse
holding compartment, and replace the fuse if necessary
(3,15 AT delayed type). Plug the unit back in and press the
main switch.
CLEANING BY ThE TEChNICAL
Check every year
Compartment ventilation flue gas cleaning
Remove the fixing screws and remove the smoke fan for
cleaning of the same. Perform the task with the greatest
care not to bend the fan blades.
Clean flue
Clean the flue system especially near the fittings to “T”,
curves and any horizontal sections. Is necessary to check
and remove any deposit of ash and soot before the same
clogging the passage of smoke.
Cleaning the exchanger
Lift the upper door that covers the tube by unscrewing the
screws. Pull out the 16 soft brush and wipe with a clean
16 exchanger tubes.
Perform cleaning after removing the springs inserted
in each pipe. The operation is simple by removing the
springs from the horizontal pin to which they are attached.
To do this, the horizontal pin can be pulled through a hole
in the wall of the thermostove body.
Now the upper section to the heat exchanger is free
from any encumbrance so as to allow a perfect cleaning.
Once a year is also recommended to clean the upper
compartment of the exchanger. To make a proper cleaning
is recommended to suck the ash, remove all horizontal
joints with a screwdriver, then again suck the ash.
Summary of Contents for CentroPelet ZV 20
Page 27: ...GB...
