6
Remote Control - First Time Use and Battery Replacement
The remote control battery has been previously installed is and ready for immedi-
ate use. For the first time use, pull out the insulation tag from the button battery tray
before operating the remote control. When the remote control stops functioning, you
must replace the battery with a new one. To do so, locate the battery compartment on
the side of the remote and follow the steps below:
1. Squeeze the notch labeled “Tab A” while pulling
the“ battery door latch B” out towards you. This
will allow the battery holder to release and pop
out. Please refer to the picture on the right side.
2. Insert a “CR2025” 3V lithium battery. Make cer-
tain to follow the correct polarity, following the
direction of the corresponding symbols (+/–).
3. Secure battery and push the battery holder back
into the remote control until fully inserted.
Installing the Dock Adapter
To guarantee that your iPod/iPhone will fit properly into the built-in universal dock,
several detachable dock adapters for older iPods are included with this product. Please
check the bottom of dock adapters to determine compatibility with your iPod.
1. Inserting the dock adapter
a. Choose a dock adapter that corresponds with the iPod/iPhone you would like to
dock. Using the correct dock adapter ensures a proper fit.
b. Gently push the dock adapter down into the universal dock.
c. Carefully place your iPod into the universal dock. Please note that iPod/iPhone
must not be in a case or “skin”.
2. Removing the dock adapter
Remove your iPod, grasp the dock adapter and lift upwards carefully.
GETTING STARTED
Battery
door latch
A
B
