Section 4.0 Safety Instructions
4.1 Caution Use Only As Directed
Use only for surface and fabric cleaning, disinfection and deodorisation.
DO NOT overfill or under-fill the jug.
Use the recommended additives only in the quantities stated.
DO NOT move the unit during operation.
STORE SAFELY
–
Do not keep the activated water in the refrigerator where it can be
confused with drinking water.
Produce only as much fluid as necessary and use as instructed. Use activated solutions
within 24 hours
–
sterilising and deodorising power is reduced gradually over time.
Unused solutions can be disposed in a sink. Unused solutions can also be reactivated,
restoring the disinfection, cleaning and deodorising power.
Unplug the base from the power supply after use.
Avoid direct exposure of the unit to the sun. This might cause fire or damage.
DO NOT use ground water, polluted water or excessively hard water to fill the bottle or jug.
Use water of temperature ranges from 5℃ to 40℃.
Use only 2 grams of salt in 1 litre of water. This is 1 level measuring spoon. Dissolve
salt in the water by mixing thoroughly.
DO NOT add too much additive (salt)
–
the device will automatically stop if excessive
salt is used.
DO NOT use in an enclosed space. Use only in a well-ventilated area.
DO NOT swallow the activated solution. If swallowed, seek medical advice.
DO NOT use this unit and activated solution near fire.
Wash hands after use. People with sensitive or damaged skin should avoid
prolonged contact with the product.
Keep out of the reach of children and pets.
DO NOT spray into your eyes. In case of contact with eyes, rinse immediately with
plenty of water and seek medical advice.
4.2 Directions for Safe Use
The water supply MUST be from normal tap water with appropriate hardness.
Use water with a pH range of pH6 - pH8, and a hardness of less than 200 ppm
Low calcium water is recommended.
DO NOT use ground water, polluted water or excessively hard water.
Water temperature range: 5℃ to 40℃ only
4.3 Water quality
