3.3 How to use and activate the Toucan Eco Ⅲ Unit
1
2
6
5
7
3
4
Fill the jug with tap water to the 1 litre mark. The water should be between 5 to 35⁰ C,
and do not use purified water
Add 2g of table salt - that’s a flat measure using the short measuring spoon provided. No
more or less as this affects the electrolysis. If too much salt is added, rinse out the jug
and start again. Do not use rock salt.
Stir the solution with the long spoon at least 8 times in the centre of the jug to fully
dissolve the salt. The salt acts as an electrolyte and if it accumulates on the electrode the
product will not work. Place the lid on the jug, and wipe any water away from the
electrodes on the bottom of the jug.
Connect the adapter to the base unit, plug into a wall socket and turn the power on at
the wall. The base will beep and light flash twice.
Place the jug on its base. The base will beep once and the white button will remain lit.
Activate the solution by pressing the button once. After 3 seconds the base light will flash
and beep, the jug will light up blue and microbubbles appear as electrolysis begins.
After 5 minutes the base beeps, blue jug and white button lights stay on, and solution
stops bubbling. It’s now ready to use and pour into the bottle. After 3 minutes you can
activate again, indicated by a beep and lights switching off. This prevents the device from
overheating.
Use the solution to safely spray, wipe or mop any surface clean and germ free. It can also
be used as a deodoriser by killing the germs that creates the smell.
NOTE: For IMPORTANT information regarding correct usage - see
Section 5
