Page 9
SKU 96314
for technical questions, please call 1-800-444-3353.
inSpection, MAintenAnce, And cleAning
wArning! Make sure the Throttle Lever (5) of the Spot Weld Drill is in its “OFF”
(full up) position and that the tool is detached from its air supply before performing
any inspection, maintenance, or cleaning procedures.
before eAcH uSe, inspect the general condition of the Spot Weld Drill. Check
for loose screws, misalignment or binding of moving parts, cracked or broken parts,
and any other condition that may affect its safe operation. If abnormal noise or
vibration occurs, have the problem corrected before further use.
do not use dam-
aged equipment.
MAintenAnce cHArt
Maintenance type
before
use
After
use
Inspect tool for damage
(see paragraph above)
X
Wipe off with clean, moist
cloth
X
troubleSHooting
problem
possible causes
probable Solutions
Spot Weld Drill will not
start
Closed compressor air valve
Not enough air pressure from
compressor due to leaks at air line
connections, or cracks in air hoses.
Air flow regulator on compressor is
set too low
1.
2.
3.
Open air valve.
Check all hose connections and
check air lines for leaks. (Soapy
water is a good tool. Watch for
bubbles) Replace any leaking
hoses. DO NOT FIX WITH TAPE
OR WRAPS OF ANY KIND
Check gauge on regulator, make
sure it is set for 90 PSI.
1.
2.
3.
Drill Bit (49) does not
cut all the way through
the weld
Adjustment Screw (57) is turned in too
far
Turn Adjustment Screw out
(counterclockwise) allowing the Drill
Bit (49) to drill farther into the metal.
