Page 7
SKU 94847
For technical questions, please call 1-800-444-3353
Maintenance
1. After each use, wipe all components of the Planishing Hammer with a clean cloth to
remove any dirt and grease buildup.
2. To maintain tool life, always lubricate the air line by adding a few drops of pneumatic
tool oil to the air line (or Air Inlet) before each use. Or, install the automatic oiler-filter
system as illustrated on page 5.
3. Before each use, drain water out of the air compressor tank and condensation from
the air lines. Refer to the Air Compressor Operation Manual.
4. Cover the Planishing Hammer and keep in a clean and dry location.
Parts List
Part
Description
Qty.
1
“C” Frame
1
2
Screw
1
3
Hammer Head
1
4
Hammer Sleeve
1
5
Anvil (small, medium, large)
3
6
Range Adjust Block
1
7
Adjustable Pole
1
8
Screw
1
9
Stopper Pin
1
10
Air Hammer
1
11
Regulator
1
12
Air Hose
1
13
Switch Assembly
1
14
Cover
1
15
Quick Connector (male)
1
16
PVC Air Hose
1
17
Male Thread Fitting
1
18
Hose Clamp
2
19
Screw
4
Note:
Some parts are listed and shown for illustration purposes only and are not available
individually as replacement parts.
PLEASE READ THE FOLLOWING CAREFULLY
THE MANUFACTURER AND/OR DISTRIBUTOR HAS PROVIDED THE PARTS DIAGRAM IN THIS MANUAL
AS A REFERENCE TOOL ONLY. NEITHER THE MANUFACTURER NOR DISTRIBUTOR MAKES ANY
REPRESENTATION OR WARRANTY OF ANY KIND TO THE BUYER THAT HE OR SHE IS QUALIFIED TO
MAKE ANY REPAIRS TO THE PRODUCT OR THAT HE OR SHE IS QUALIFIED TO REPLACE ANY PARTS
OF THE PRODUCT. IN FACT, THE MANUFACTURER AND/OR DISTRIBUTOR EXPRESSLY STATES THAT
ALL REPAIRS AND PARTS REPLACEMENTS SHOULD BE UNDERTAKEN BY CERTIFIED AND LICENSED
TECHNICIANS AND NOT BY THE BUYER. THE BUYER ASSUMES ALL RISK AND LIABILITY ARISING OUT OF
HIS OR HER REPAIRS TO THE ORIGINAL PRODUCT OR REPLACEMENT PARTS THERETO, OR ARISING
OUT OF HIS OR HER INSTALLATION OF REPLACEMENT PARTS THERETO.
