Page 9
skU 93981
For technical questions, please call 1-800-444-3353
Mounting Sanding Disc
Place the Belt sander so that it is sitting on its feet.
on disc (22), loosen the set screw (17) with a Hex Wrench (not supplied).
slide the disc all the way onto the drive shaft (6) so that the set screw (17) faces the
flat surface on the drive shaft (6).
Disc (22)
Set Screw (17)
Drive Shaft (6)
securely tighten the set screw (17).
Table Installation
Find the Table Bar (49) and insert one end into the mounting holes under the Table
(59) as shown below, left.
flat Washer (54) and
Adjusting Knob (55)
Rod
(47)
Table Bar (49)
Table (59)
Pivot Bracket (48)
Table Tilt
Trunion (56)
hex Bolt (51), flat Washer
(53), and Lock Washer (52)
insert the other end of the Table Bar (end with the angle Pointer #58) into the Pivot
Bracket (48).
1.
2.
3.
4.
1.
2.
