Page 6
For technical questions, please call 1-800-444-3353.
Item 60500
SAFET
y
Op
ERA
TION
M
AINTENAN
c
E
SETU
p
Specifications
Electrical Rating
120V~ / 60Hz / 2.5A
Motor No Load Speed
1725 RPM
Blade Speed
2460 FPM
Throat Depth
9″
Table Pivot (Tilt) Capacity 0~45° (Right Tilt Only)
Blade Size
1/8″ – 1/2″ W x 0.01″ T x 62″ L
Miter Gauge
0~60° Left & Right
Miter Slot
5/8″ W x 1/4″ D
Base Mounting Holes
4 x 3/8″ Diameter
Setup - Before Use:
Read the ENTIRE IMpORTANT SAFETy INFORMATION section at the beginning of this
manual including all text under subheadings therein before set up or use of this product.
TO pREVENT SERIOUS INJURy FROM AccIDENTAL OpERATION:
Turn the power Switch of the tool off and unplug the tool from its electrical
outlet before performing any procedure in this section.
Note:
For additional information regarding the parts listed in the following pages,
refer to the Assembly Diagram near the end of this manual.
Mounting
1. This tool must be mounted to a level,
stable bench or table before use.
2. If the mounting surface does not have predrilled
holes that match the four holes in the Base (70) of
the Band Saw, four 3/8″ holes will have to be drilled.
3.
cAUTION! When drilling, check for
electric wiring or cables that may be in
the path of the hole(s) being drilled.
4. Secure the Band Saw to the surface
by using 3/8″ bolts, 3/8″ washers and
3/8″ hex-nuts (not included).
Summary of Contents for 60500
Page 1: ......
