SKU 38119
For technical questions, please call 1-800-444-3353.
Page 10
aSSEMbLY
cautIOn!
Consider the weight of the components and take necessary precautions
when lifting components.
assistance will be required when assembling.
before
adjustments are made, ensure that the machine is SWITCHED OFF AND
UNPLUGGED. Also make sure all locking handles and securing screws are
FULLY TIGHTENED when adjustments are completed.
Before assembling, remove all traces of preservative from the components and
wipe all parts thoroughly with a clean dry cloth. Apply a thin coating of light machine oil
to the table, column and base to prevent rust.
Part numbers described below refer to illustration on page 9.
table to column
Thread the Table Support Locking Handle (6) into the
1.
Table Support (4) from the left hand side, and leave it
loose until later.
Slide the Table Support with Table over the Column
2.
(11) and secure at a convenient position by tightening
the Table Support Locking Handle.
head to column
It may be necessary to unscrew the Head Lock Set
1.
Screws (3) slightly to ensure they do not protrude
internally, as this will prevent the head from sliding fully
into position.
With assistance, raise the Head and place it on top of
2.
the Column, ensuring it slides home fully.
Align the head with the base (7), and firmly secure with
3.
the Head Lock Set Screws (3).
Screw the three Feed Handles (15) firmly into the hub of the Feed Shaft.
4.
Installing the chuck
With the Chuck Guard lifted clear of the spindle nose, slide the work table up the
1.
column to within 6” of the spindle.
Open the jaws of the chuck to their maximum, using the Chuck Key supplied.
2.
Put a piece of scrap wood on the table to protect the Chuck Nose.
3.
Figure 2
