Page 11
SKU 32966
for technical questions, please call 1-800-444-3353.
Slide the Motor (33A) downward until the tension between on the V-Belt (12) feels
snug. Then wrench tighten all four Screws (5A) that hold the Motor onto the Upright
Plate (4A).
(See Assy. Diagram.)
Close the panel on the Left Protect Plate (28A).
(See Assy. Diagram.)
Attach the Belt Guard (6) to the rear of the Top Plate (1A) using the Screws (66),
Lock Washers (67), and Nuts (68).
(See Assy. Diagram.)
OpeRATING INSTRucTIONS
TO RAISe AND lOWeR THe fRONT AND ReAR TABleS
To raise or lower the Front Table (2), use the depth Adjusting Wheel (63) located
under the Front Table.
NOTe:
For greater accuracy, use the Depth Scale (7).
(See figure e.)
To raise or lower the Rear Table (3), use the depth Adjusting Wheel (63) located
under the Rear Table.
NOTe:
Always adjust the Front Table first to the desired
depth. Then use a straight edge to align the depth of the Rear Table with that of
the Front Table.
(See figure e.)
NOTe:
Two Gibs (5) are provided and were pre-adjusted by the manufacturer. Both
are inserted under the Front Table (2) and Rear Table (3) into grooves between the
2.
3.
4.
1.
2.
3.
fRONT TABle (2)
ReAR TABle (3)
feNce BODy (4)
ADJuSTING WHeel (63)
ADJuSTING WHeel (63)
DepTH ScAle (7)
pOWeR SWITcH (14A)
fIGuRe e
Brought To You By Augusta Flint
