12
12
Zephiro Fog 900 User Manual
Eng
y
All fog machines will have condensation or moisture around the Output Deflec-
tor.
y
All fog machines have heating-cooling cycles. When internal temperature drops
to minimum, the pump automatically turns on and begins heating. Once heating
is complete, the machine starts to spray fog again.
y
In the case of a serious operating problem, stop using the unit immediately.
Never try to repair the unit by yourself Repairs carried out by unskilled people
can lead to damage or malfunction. Please contact the nearest authorized tech-
nical assistance center Always use the same type of spare parts
y
Never connect the device to a dimmer pack.
y
Make sure the power cable in never crimped or damaged and never disconnect
it by pulling or tugging on the cable.
WARNING: Fog machines may set off Smoke Alarms.
7.1. Routine Maintenance And Common Faults
ATTENTION: Periodically clean your machine to reduce replacement parts and
repair expenses.
y
Poor fog liquid can cause blockage. It is recommended to use high quality fog
liquid.
y
The machine might get blocked due to high concentration fluid, not-pure fluid
or overheat, so regular care and maintenance can ensure long-term use. After
about 40 hours continue use, please prepare an 80% distilled water and 20%
white vinegar blend to remove any accumulated impurities inside boiler and
pipe, as following:
y
Wash the pipe in the tank and its filter head.
y
Pour out any liquid inside, and replace with the cleaning liquid (80% distilled
water and 20% white vinegar), turn on power, keep it operating till the cleaning
liquid runs out.
y
If the fog turns less, and the pump makes noise, switch off the unit immediately
and check fluid level, fuse, controller interface and power plug. If all of these are
normal, please connect power again. If problems still continue, please contact
the supplier.
y
When you shut down the machine, it is recommended that you remove any
remaining fluid inside. Especially when the machine will not be used for a long
time. It is recommended that you open the tank, remove the fluid hose and
place it next to the tank in open air.
y
After use, let the fog machine cool down before transporting it by the handle.
Small bits of fog may still be emitted just after the machine is turned off. Let the
machine cool down for at least 20 minutes and only transport it when the hous-
ing of the machine reaches a temperature that is comfortable enough to handle.
