CO
2
Leak Detector
7
6. GETTING STARTED
6-1 Installing Batteries
Loose the screw and remove the battery
compartment door located on the bottom of the
instrument as show below (Fig.1).
Install Lithium-ion battery pack.
Reinstall the battery cover by aligning it with the
handle.
When the battery power is low, the red LED low battery
indicator illuminates. The battery should be recharged
as quickly as possible.
6-2 Charging
When the battery is being charged, the power
indicating LED will be on. It will be off after charging is
completed.
During the charging period, if the power indicating LED
blinks, it may be caused by the following reasons.
(1) Charging period is too long and the detector is
sending the warning signal. Please disconnect the
power and try again later. If the situation remains,
the battery might need to be replaced.
(2) The temperature of the battery is too high for
charging operation. Disconnect the power and wait
until it cools down then try it again.
(3) This detector is using Lithium-ion rechargeable
battery and there will not be any charging memory
