Cengar CS75, Operating Instructions

Page: 4 / 5

CS INSTRUCTIONS USING THE PIPE CLAMP
6 7
CS75 EXPLODED VIEW
ITEM PART NO. DESCRIPTION
NUMBER
PER TOOL ITEM
PART
NO.
DESCRIPTION
NUMBER
PER TOOL
1 9550 Handle 1 21 1143A Front End Cap 1
2 9554 Isolator body 1 22 54160 Front Cap Screws 3
3 9553 Oil Cap & Retainer 1 23 54160 Screws - Nosepiece 2
4 9555 Isolator Nozzle 1 24 5075 Nosepiece (3/4”) 1
5 9559 Oil Control Ball 1 25 1147 Centre Shaft 1
6 9334A Spring 1 26 55516 Screws for above 2
7 9561 ‘O’ Ring Large 2 27 1150 Link to Pistons 1
8 9560 ‘O’ Ring Small 2 28 1248 Top Piston 1
9 9557 Détente Spring 1 29 1252 Bottom Piston 1
10 9556A Lock Screw 1 30 1147 Pin to Link 2
2to10 9552 Isolator Assembly 31 1147 Pin to Pedestal 1
11 51834 Roll Pin-Trigger 2 32 1153-5 Pedestal 1
12 50034 Valve in Handle 1 33 5540 Screw-Handle Front 8
13 9502 Trigger 1 34 5520 Screw-Front Lower 2
14 9506 Filter/Gauze 1 35 9564 Isolator Seal 1
15 9538 Gasket 2 36 W55 Serrated Washer 10
16 9507 Valve Unit 1 37 5068 Screw-Blade Grip 2
17 1241L Body 1 38 9510 Piston Seal 2
18 1142 Gasket-Front End 1 39 CR1 Carrier for Clamp 1
19 1243 Front End Complete 1 40 - Serial Number-
20 SG1 Silencer Guard
1. When using the pipe clamp fit the blade into the machine with the teeth
facing upwards and towards the machine. Avoid handling the blade teeth.
2. Secure blade by tightening both grip screws with supplied T key.
3. Fit the spigot (CP1/3) into the appropriate side of the clamp in the
front of the two holes in the clamp body and tighten securing nut.
4. Position the clamp on the pipe with the chain around the pipe and
tighten using the tommy bar (end of CP1/6). Ensure the clamp is
perpendicular to the pipe for an accurate cut (Fig.1).
5. Mount the machine onto the spigot whilst pressing down the
carrier latch. Slide the machine into the groove in the spigot.
Ensure it is correctly located.
6. When mounted correctly the blade should be under the pipe so
that the weight of the machine applies the cutting force to the
blade. (Fig.2).
7. Attach air supply (5-6 bar).
8. Press the trigger to start the machine and lock trigger in place by
sliding the trigger downwards. Gently bring the blade into contact
with the work gradually release the weight of the machine to allow
the cut to take place with out extra force.
9. When the cut is complete release slide the trigger upwards and
release the trigger. Remove air supply before attempting to
remove machine from spigot (reverse of 5 above).
8
7
FIGURE 2
FIGURE 1
( L U B 0 1 )
( 9 5 0 7 C FA )