Page 8
SKU96959
for technical questions, please call 1-800-444-3353.
general operating instructions
Turn on the laser beams by rotating the Locking Device (13) lever to the
1.
horizontal position (ON). By default the horizontal beam will turn on.
Switch the laser beam(s) to vertical (or multi-beam) using the Adjustment
2.
Buttons (21) on the side of the housing. The laser beam(s) will project a line
(either vertical or horizontal) onto the surface you wish to work on. The level also
reflects down a red dot (when a tripod is not used) for exact placement of the
level.
While holding the base with one hand, rotate the Shell (3) positioning the lasers
3.
on the job. For finer adjustment, the Fine Tuning Device (17) can rotate the Shell
(3) within 15 degrees.
The Self Level Laser has five red laser lines (vertical x4, horizontal or cross-line).
4.
Each of the lasers, after the Locking Device is in the horizontal (ON) position,
5.
can be turned ON or OFF by pressing their corresponding button (V, H, H) on the
Switch (20).
If the tool is moved for other projects, remember to lock the Beam Heads, using
6.
the Locking Device (13) lever. You must repeat steps to re-level the housing.
Turn off the tool after use. Clean, then store the tool indoors out of children’s
7.
reach. If the Self Level Laser is to be stored for extended periods of time, remove
the batteries from the Battery Compartment (4).
accuracy checking
Due to the complicated nature of the procedures, only a qualified service
technician should attempt to set or re-set the lasers.
After manually adjusting the base stand of the unit, if you find that the horizontal
7.
laser is blinking, the level is out of the +/- 3° self adjust range. The level will need
to be repositioned and the Supporting Feet 18 leveled again. When proprely
adjusted the laser will not blink.
Any time the Locking Device (13) is rotated from the vertical (OFF) to the
8.
horizontal (ON) position, the laser beam Module (9) turns on and defaults to the
horizontal. Use the three Adjustment Buttons (21) on the side of the Housing to
switch the beams to vertical, multi-beam, or any combination thereof.
REV 08b
