8
2. INSTRUCTIONS FOR USE
The part reference includes the following:
– Hydraulic tool fi tted with Metabo or Makita battery (depends on the tool version).
– Spare battery.
– Battery charger (depends on the tool version).
– Canvas bag.
– Shoulder strap.
– USB cable (Ref. to
section 5
page 11).
The tool can be easily carried using either the main handle (4) or the shoulder strap attached
to the two eyelets of the wrist strap (9) (see FIG. 7).
The tool can be held in one hand while positioning the conductor with the other.
Before starting any work, check the battery charge and recharge it if necessary following
the instructions in the battery charger user manual.
To replace the battery, grip the tool as illustrated in the FIG. 1a or 1b
Press the release button (8) and slide the battery out unlocking it.
2.1) Crimping mode
With the tool in the rest position (the ram fully retracted), proceed as follows:
Insert the crimping jaws into the tool (see
section 3.1
).
If necessary, select the appropriate die set for the connector to be crimped and insert the
dies into the jaws (see
section 3.2
).
Insert the conductor into the connector and position the connector between the groove or
die set (see FIG. 4). Ensure the correct location of the crimp.
Position the connector in the die groove and ensure the correct location of the crimp.
NOTE
: when more than one
compression is required, proceed
according to the sequence and
direction indicated in the fi gure
opposite, uniformly spacing the
compressions.
Press operating button (3) to activate the motor-pump and advance the ram.
To halt the advancement, release the operating button and the motor will cut out.
terminal
connector
1 2
3
1 2
1
3
2
3
conduc
tor
conduc
tor