6
Before starting work on electrical equipment, please ensure that either there are no live parts
in the immediate working area or that precautions are taken for working near live parts in
accordance with EN50110-1.
Do not use this tool on, or near, live conductors without proper personal
protective equipment.
Electrical Shock Hazard: The tool is not insulated and the jaws will conduct
electricity. This product should be used only by persons knowledgeable in
the safe use of jaws and crimpers. Failure to observe this warning could result
in injury or death.
Do not use the tool for purposes other than those intended by
Cembre
.
The operator should concentrate on the work being performed and be careful to maintain
a balanced working position.
Avoid dirty surfaces as dust and sand are a danger to any electro-hydraulic equipment.
Protect the tool and accessories from rain and moisture. Water will damage the tool and
battery. Electro-hydraulic tools should not be operated in pouring rain.
Work in a clean, uncluttered area and keep persons away from immediate work area.
Before each use, verify the integrity of the tool. Replace any worn, possibly damaged or missing
parts with original
Cembre
spares.
Inspect the blades before each use of the cutting jaw.
Do not use damaged blades.
Damaged blades can break and cause injury or damage to the tool.
Wear eye protection as metal chips can fl y from blades when cutting.
Pay attention when cutting short, free pieces of steel rod or rope as they may fl y off danger-
ously, causing injury to the operator or persons nearby.
Do not cut live cables or conductors.
The tool is unsuitable for continuous use and should be allowed to cool down following un-
interrupted, successive operations. For example, having exhausted a fully charged battery in
one session, delay battery replacement for a few minutes.
WARNINGS