Page 12
2.5 Powering Up The MAXX-700 System
Plug in the power cable into each laser unit. Please observe the following events (A to D)
illustrated in Figure 2-7on Page 12.
WARNING
- Repeatedly turning on and off the MAXX-700 units can cause damage to the hardware.
Figure 2-7 Powering Up A MAXX-700
A
. The
Power LED
on the
bottom left side should be on
immediately.
B.
The
Unit Number LED
displays the unit number
.
C.
The laser starts
beaming
and
the brightness of the laser is
adjusted to ambient lighting
seconds later.
D.
The
Network Status LED
is
solid
green
to
signal
a
successful connection from the
unit to the remote control. The
network status LED starts
blinking if the laser unit detects
that there is no connection
established.
