12
4. Read the voltage in the display. Reset the function
switch to successively lower V AC positions to obtain
a higher resolution reading. The display will indicate
the proper decimal point and value.
DC CURRENT MEASUREMENTS
CAUTION:
Do not make current measurements on the
10A scale for longer than 30 seconds. Exceeding 30
seconds may cause damage to the meter and/or the test
leads.
1. Insert the black test lead banana
plug into the negative (COM) jack.
2. For current measurements up to
200mA DC, set the function switch
to the highest DC mA position and
insert the red test lead banana plug
into the (mA) jack.
3. For current measurements up to
10A DC, set the function switch to
the 10A range and insert the red test lead banana plug
into the (10A) jack.
4. Remove power from the circuit under test, then open up
the circuit at the point where you wish to measure
current.
Summary of Contents for DT-912
Page 2: ...1...
