WARNING:
To avoid electric shock, do not operate the meter until the
battery door is in place and fastened securely.
NOTE
: If your meter does not work properly, check the fuses and battery
to make sure that they are still good and that they are properly inserted.
REPLACING THE FUSES
WARNING
: To avoid electric shock, disconnect the test leads from any
source of voltage before removing the fuse door.
1. Disconnect the test leads from the meter and any item under test.
2. Open the fuse door by loosening the screw on the door using a Phillips
head screwdriver.
3. Remove the old fuse from its holder by gently pulling it out.
3.
Install the new fuse into the holder.
4.
Always use a fuse of the proper size and value (0.5A/1000V fast
blow for the 400mA range, 10A/1000V fast blow for the 10A range).
1.
Put the fuse door back in place. Insert the screw and tighten it securely.
WARNING
: To avoid electric shock, do not operate your meter until the
fuse door is in place and fastened securely.
