Celsius CELDH145, Operating Instructions Manual

Page: 7 / 12

OPERATING INSTRUCTIONS
Always choose a safe location for the Dehumidifier, keeping in mind the safety precautions
outlined. Ensure all packaging has been removed from the unit before use. This appliance
requires no installation, it should be used solely as a portable appliance. Leave the appliance to
stand for one hour after transport or after the unit has been on its side, before connecting it to
the mains supply to let the refrigerant settle.
1. The Power indicator light will illuminate when the unit is plugged in, regardless of whether
the unit is operating or not.
2. Press Power button once to start operation. Press it again to stop operation.
3. Press Setting button to set the desired humidity level in the room, humidity can be set from
40% to 80% in 5% increments.
Note: When environment humidity is lower than the selected humidity by 2%, the compressor
will stop and the fan will stop working 3 minutes later. When environment humidity is equal to
or higher than the selected humidity by 2%, the compressor will restart (once the 3-minute
compressor protection time has elapsed).
TIMER
1.
Press Timer button to set the timer.
2. Use the Timer button to program the time when the unit automatically turns itself on and
off. Press the button, it will be circulate from 00 to 24 in 1 hour increments.
3. The programmed time will be cancelled if the dehumidifier is switched to manual. The
programmed time remains unchanged if the machine stops working due to the water tank
being full or during defrosting. If you want to cancel the timer programming, press the
button and adjust the time to 00.
FAN SPEED
Press Speed button to set the desired fan speed. It can be adjusted between high speed and low
speed.
WHEN THE WATER CONTAINER IS FULL
A beep signal will sound 15 times and the tank full indicator light will illuminate.
The compressor will stop automatically. This will also stop the dehumidification process.
Empty the water container and replace it in the correct position. The Dehumidifier will continue
dehumidifying when the compressor automatically restarts after approximately three minutes.
Note: Do not remove the float from the water tank. The water full sensor will no longer be able
to detect the water level correctly without the float and water may leak from the water tank.
When replacing the drainage tank, press the tank firmly into place with both hands. If the tank is
not positioned properly, the “TANK FULL” sensor will be activated, and the dehumidifier will not
operate.
This Dehumidifier is designed to provide an optimum performance. It is not recommended to
operate in ambient temperature exceeding 35
° C or lower than 5 ° C.
Ensure all external windows and doors are closed before turning on the unit.
Operating Your Dehumidifier