49
Web Setting
Logo Upload
- Changes the logo image.
- For the process, refer to that of “Firmware Update”
- The filename must be “logo.gif” (Maximum size : 567x175)
OSD Logo Upload
- Changes the logo image on OSD.
- For the process, refer to that of “Firmware Update”
- The filename must be “osd_logo.bmp” (Maximum size : 120x38)
<Making “osd_logo.bmp” with Windows Paint>
Control Protocol Upload
- A user can add the protocol of a PTZ camera or a receiver.
- Please ask the supplier of CamPilot MRH100 for the protocol.
- For the process, refer to that of “Firmware Update”
50
Web Setting
• Expert > Report
Report
- Click the item to check all setting values of CamPilot MRH100.
- It is available to take a memo on the “MEMO” area of the report page.
- It is available to print out these pages. Click the “Print” button.
• Reboot
- To apply the changed setting, reboot CamPilot MRH100.
• Logout
- Back to the initial connection page
► Confirmation Dialog
51
Trouble-shooting
Before sending the CamPilot MRH100 out for repair, check the items below.
If the problem persists after checking these items, contact your service center.
▲
▲
▲
▲
If no image appears
- Is the LAN cable attached securely?
- Are the power and voltage normal?
- Is the connected camera normal?
- Is there adequate illumination?
▲
▲
▲
▲
If the image is unclear
- Is the connected camera lens in focus?
- Is the connected camera lens dirty?
- Dirt or fingerprints on the lens can adversely affect the images.
Gently wipe any dirt or fingerprints off the lens with a soft cloth or lens
cleaning paper and cleaning fluid (commercially available).
- Is the connected monitor adjusted correctly?
▲
▲
▲
▲
If the Audio is not work
- Is the audio cable attached securely?
- Are the connected devices(amplifier, microphone, speaker and etc.) normal?
- Are the Client software and devices normal?
▲
▲
▲
▲
If the PTZ control is not work
- Is the RS485 cable attached securely?
- Is the connected PTZ Camera or PTZ driver normal?
- Is the RS485 control setting(Protocol, Baudrate, Control ID and etc.) correct?
▲
▲
▲
▲
If the DIO is not work
- Is the DIO cable attached securely?
- Is the connected sensor or alarm device normal?
