www.cellarcool.com | Page 5
Receiving and Inspecting the System
•
Lift only at the designated hand hold locations on the shipping container or fully support the unit from
underneath. A shipment may include one or more boxes containing accessories.
•
Before opening the container, inspect the packaging for any obvious signs of damage or mishandling.
•
Write any discrepancy or visual damage on the Bill of Lading before signing.
•
Allow the condensing unit to sit 24 hours prior to start up. The Condensing Unit can be placed in the
installation location, piped and evacuated during this time.
•
Note:
CellarCool units are manufactured in the USA and tested prior to shipment.
Review the Packing Slip to Verify Contents
•
Check the model number to ensure it is correct.
•
Check that all factory options ordered are listed.
If any items listed on the packing slip do not match your order information,
contact CellarCool Customer Service immediately.
Check the Box for the following contents:
RECEIVING & INSPECTING THE SYSTEM
Please leave the unit in its original box until you are ready for installation. This will allow you to move the product
safely without damaging it. When you are ready to remove the product from the box, refer to the installation
instructions.
TIP:
Save your box and all packaging materials. They provide the only safe means of transporting/shipping the unit.
(1) Condensing Unit
Main Evaporator Unit (Fan Coil Unit) Box
Main Condensing Unit Box:
(1) WM 2500-C or WM 2500-CR Evaporator Unit (Fan Coil Unit)
If the WM 2500-S was ordered the
Condensing Unit Box will be included
(4) 2” #8 Hex Head Screws
(1) 10 FT. 1/2” Drain Line
(1) ¼” Sight Glass
(1) ¼” Filter Drier
(1) 10” Piece of Cork Tape
(1) Split System Owner’s Manual
(1) Unit Specific Installation Guide
(1) Evaporator Mounting Template
(1) Split System Warranty Checklist
