www.cellarcool.com | Page 11
CX SERIES
PREPARING THE UNIT FOR INSTALLATION
Two-Piece Mounting Flanges
The unit utilizes two (2) mounting flanges that attach to each side
of the unit on the exterior side of the installation location.
INSTALLING THE UNIT
Installing the Unit
1. Slide the unit into the installation location from inside the cellar. Make sure the controller
side of the unit is inside of the cellar.
Note: If you use decorative moulding, it should be
attached to the walls and never to the cooling unit itself.
The moulding itself should be removable incase the unit
needs servicing.
Applying Insulation Tape
Locate the two (2) 17-inch pieces and two (2) 20-inch pieces of
insulation foam tape provided with the unit. Peel back the white-
paper adhesive covering and place on the mounting flanges
as shown. The 20-inch pieces will go between the unit and the
bracket, and the 17-inch pieces will go between the bracket and
the wall. This foam creates a tight seal around the unit.
Front of Unit
Cellar Wall
