Celestron 11074-XLT, Instruction Manual

Page: 38 / 61

38
4. Release the shutter using a cable release.
5. Wait for the vibration caused by releasing the shutter to diminish. Also, wait for a moment of good seeing.
6. Remove the black card from in front of the telescope for the duration of the exposure (see accompanying table).
7. Replace the black card over the front of the telescope.
8. Close the camera's shutter.
Advance the film and you are ready for your next exposure. Don't forget to take photos of varying duration and keep accurate
records of what you have done. Record the date, telescope, exposure duration, eyepiece, f/ratio, film, and some comments on the
seeing conditions.
The following table lists exposures for eyepiece projection with a 10mm eyepiece. All exposure times are listed in seconds or
fractions of a second.
Planet ISO 50 ISO 100 ISO 200 ISO 400
Moon 4 2 1 1/2
Mercury 16 8 4 2
Venus 1/2 1/4 1/8 1/15
Mars 16 8 4 2
Jupiter
8 4 2 1
Saturn 16 8 4 2
The exposure times listed here should be used as a starting point. Always make exposures that are longer and shorter than the
recommended time. Also, take a few photos at each shutter speed. This will ensure that you get a good photo. It is not uncommon
to go through an entire roll of 36 exposures and have only one good shot.
NOTE: Don't expect to record more detail than you can see visually in the eyepiece at the time you are photographing.
Once you have mastered the technique, experiment with different films, different focal length eyepieces, and even different filters.
L
L
o
o
n
n
g
g
E
E
x
x
p
p
o
o
s
s
u
u
r
r
e
e
P
P
r
r
i
i
m
m
e
e
F
F
o
o
c
c
u
u
s
s
P
P
h
h
o
o
t
t
o
o
g
g
r
r
a
a
p
p
h
h
y
y
This is the last form of celestial photography to be attempted after others have been mastered. It is intended primarily for deep sky
objects, that is objects outside our solar system which includes star clusters, nebulae, and galaxies. While it may seem that high
magnification is required for these objects, just the opposite is true. Most of these objects cover large angular areas and fit nicely
into the prime focus field of your telescope. The brightness of these objects, however, requires long exposure times and, as a result,
are rather difficult.
There are several techniques for this type of photography, and the one chosen will determine the standard accessories needed. The
best method for long exposure deep sky astrophotography is with an off-axis guider. This device allows you to photograph and
guide through the telescope simultaneously. Celestron offers a very special and advanced off-axis guider, called the Radial Guider
(#94176). In addition, you will need a T-Ring to attach your camera to the Radial Guider.
Other equipment needs include a guiding eyepiece. Unlike other forms of astrophotography which allows for fairly loose guiding,
prime focus requires meticulous guiding for long periods. To accomplish this you need a guiding ocular with an illuminated reticle
to monitor your guide star. For this purpose, Celestron offers the Micro Guide Eyepiece (#94171) Here is a brief summary of the
technique.
1. Polar align the telescope using an optional equatorial wedge. To polar align the CPC you must select EQ North Align (or
EO South Align) from the alignment options. For more information on polar aligning, see the Polar Alignment section
earlier in the manual.
2. Remove all visual accessories.
3. Thread the Radial Guider onto your telescope.
Table 8-2
Recommended exposure time for photographing planets.