Celect CC908-RF, Installation And Operation Instructions Manual, Page: 2 / 8

2
IMPORTANT SAFETY INFORMATION

Always turn off power at the main power source by unscrewing fuse or switching circuit
breaker to the off position before installing, removing, cleaning, or servicing this thermostat.

Read all of the information in this manual before installing this thermostat.

Only a professional contractor should install this thermostat.

All wiring must conform to local and national building and electrical codes and ordinances.

This thermostat has a removable fuse to protect the system from damage. If system is not
operating properly, check wiring and replace fuse if necessary.

Use this thermostat only as described in this manual.

Note: the product long time not use it, please detach the battery, prevent the battery fluid
leakage, damaged products.
INSTALL THE CONTROL CENTRE
Screw for mounting thermostat to wall
Base
Control panel
Fixing screw
1. Remove 2 screws from the bottom of thermostat. (See Figure 1) Gently pull the control panel
straight off the base. Forcing or prying on the thermostat will cause damage to the unit.
2. Push power base into wall.
3. Using two mounting screws mount the power base to the wall. Place a level against bottom of
base, adjust until level, and then tighten screws. (Leveling is for appearance only and will not
affect thermostat operation.)
4. Replace control panel on the power base and fix power base and control panel by removed two
screws in item 1.
KEYBOARD, DISPLAY AND SWITCH DESCRIOPTION OF CONTROL CENTRE
Figure1
Figure 2 Figure 3
(17)
(16)
(15)
(18)
(14)
(13)
(12)
(11)
(9) (10)
(8)