FIXING
This heater is designed for surface installation to any ceiling that can adequately support the unit.
Fixings are made through the top flat section of the heater body using the 4 No 5mm holes provided. This
section must be flat on the ceiling as the edges of the cover are designed to fit against the ceiling.
Securely fix the heater and make off the electrical connections taking into account the routing of cables in
relation to the cover.
Re fix the cover ensuring the fan outlet is adjacent to the smaller outlet grille.
The unit
weighs 9kgs.
Remove the front cover of the unit
Ensure fixings and cables are clear of moving parts and the heater elements.
The manufacturers reserve the right to change the specification at any time without prior notice EO&E
ELECTRICAL CONNECTION
The heater should be installed in accordance with the latest edition of the IEE Requirements for Electrical
Installation (BS 7671:2001)
Position remote switch unit in suitable location
Select cabling with 4 cores and earth of appropriate size for current and volt drop.
Pass cable/s through cord grip in top of unit. Leave sufficient length for connection but ensuring cables do
not foul blower unit. Make off connections to connector block and earth stud in accordance with circuit
diagram RCH-W-007 ( copy on back page and on top of unit )
If remote switching is not required connect power supply to L and N and link L,LI and LII with 1.5sqmm cable.
Tighten up cord grip. Replace connection cover plate. Replace heater cover.
Position heater in ceiling ( See Fixing )
Remove side connection cover (2 set screws)
A means of disconnection having a contact separation of 3mm in all poles should be incorporated..
IMPORTANT : always check to ensure the heating elements cannot be energised without the fan
running.
WARNING THE HEATER MUST BE EARTHED
OVER TEMPERATURE CUT OUT
Should the heater exceed normal operating temperature the over temperature cut out on the heating
elements will operate.
switch off power to the unit and allow to cool before switching on again. If the problem
persists consult a suitably qualified person.
To RESET -
MAINTENANCE
Isolate the heater and remove any build up of dust etc. every 6 months. Check that the heater has not been
covered or the airflow restricted in any way.
WARRANTY
This product is guaranteed, in accordance with our Conditions of Sale, for a period of 12 months from date of
purchase. We will repair or replace, at our discretion, any part found to be defective. We cannot accept
responsibility for any consequential liability.
The warranty will be invalid if the heater has not been installed in accordance with these instructions.
This does not affect your statutory rights.
