ISSUE 4.0
CEECO
Communication Equipment & Engineering Company
PROPRIETARY
7
PROGRAMMING CONTINUED
3.9
When you are
finished
programming,
press the “CALL & HANGUP”
button
to hang up the phone. Return the two plastic
mini-jumpers
to the
“OFF”
or outermost position, as depicted on the last page of this manual.
Secure the telephone assembly in the housing. The phone is now ready for
use.
4.0 OPERATION
To receive a call, press the "EMER/CALL" button located on the front of the
phone, when the telephone rings. The LED (if provided) will illuminate red at this
time. In order to receive incoming calls the phone must have been programmed
with a “1” under Digit 2 in section 3.8 of this manual. During ringing, the LED
will flash red and green to indicate such. When the call is answered, a normal
speakerphone conversation may take place, and the LED will shine GREEN.
After the call is complete, press the "EMER/CALL" button on the front of the
panel again to hang up the phone. If the user does not press the button on the
front of the panel when he or she is finished using the phone, then the phone will
hang up after detecting a wink (open switch interval) or the timer times out.
If the telephone has been mated with external call equipment, a call may also be
initiated by pressing the “EMER/CALL” button. The LED (if provided) will
illuminate red at this time. During ringing, the LED will flash red and green to
indicate such. The external call equipment should direct the call as intended and a
normal speakerphone conversation may take place. The LED will shine GREEN
at this time. After the call is complete, press the "EMER/CALL" button on the
front of the panel again to hang up the phone. If the user does not press the button
on the front of the panel when he or she is finished using the phone, then the
phone will hang up after detecting a wink (open switch interval) or the timer times
out.
5.0 RECOMMENDED TOOLS AND TEST EQUIPMENT
DTMF Test Set
Volt/Ohm Meter
CEECO Security Tool, 301-064
