ISSUE 4.0
CEECO
Communication Equipment & Engineering Company
PROPRIETARY
7
PROGRAMMING CONTINUED…
3.7
In most installations, the J2 mini-jumper will remain in the “1” position,
bridging the center and left copper pins. If dial tone delivery is delayed by
more than one second; however, then J2 will have to be set in the “3”
position. A simple test would be as follows: with the telephone line cord
connected to the intended telephone line, temporarily remove the J2 mini-
jumper. As accurately as possible, measure the time delay between the
moment the handset is lifted and the moment the phone receives dial tone.
Try it several times. If this time is consistently 1 second or less, position
the J2 jumper on the "1" position. Otherwise position the J2 jumper on the
"3" position to set the delay before dialing to 3 to 4 seconds.
3.8
Programming is now complete and the telephone is ready for installation.
It is highly recommended to read section 6.0 at this point and pre-test the
phone, prior to actual installation.
4.0
RECOMMENDED TOOLS AND TEST EQUIPMENT
Volt/Ohm Meter
1/4" Nut Driver
Flat Blade Screw Driver
Security Tool, CEECO Part Number 301-037 (sold separately)