ISSUE 4.0
CEECO
Communication Equipment & Engineering Company
PROPRIETARY
11
TESTING/OPERATION CONTINUED…
4.6
Be sure to determine that the microphone is muting as programmed in
section 3.5, and that the phone is in either DTMF (tone) dialing mode or
pulse dialing mode, also as programmed in section 3.5. DTMF sounds
like definite tones or beeps, whereas pulse dialing sounds like rhythmic
clicks. If the phone does not seem to be functioning as programmed, hang
up and repeat sections 3.2, 3.3, 3.5, and 3.10 only. If this does not solve
the problem, please refer to section 8.2.
4.7
Attempt to “hookswitch dial” by tapping quickly on the tongue of the
hookswitch assembly. The phone should momentarily open the line, until
the attempt is over, and then return dial tone. If not, please refer to section
8.2.
4.8
Testing is now completed and the telephone is ready for operation. Plug
the telephone line cord into the desired location (RJ11C modular jack).
The phone is now operational.
*****WARNING*****
A.
Never install telephone wiring during a lightning storm.
B.
Never install telephone jacks in wet locations unless the
jack is specifically designed for wet locations.
C.
Never touch uninsulated telephone wires or terminals
unless the telephone line has been disconnected at the
network interface.
D.
Use caution when installing or modifying telephone lines.