POWER ESPRESSO 20 BARISTA CREAM
POWER ESPRESSO 20 BARISTA CREAM
45
44
ENGLISH
ENGLISH
The froth indicator will light up and the dot indicator will start flashing to remind you to return
the dial to starting position.
After you turn it, the device will return to standby mode.
Restoring default settings
Long press the four buttons (On/off, grind, single and double) at the same time. The device
will beep and all four indicator will flash at the same time. With this, the device will return to
default settings
4. CLEANING AND MAINTENANCE
Disconnect the appliance from the power supply and allow it to cool down before cleaning.
Use a soft, damp cloth to clean the product’s surface.
Do not immerse the appliance in water or other liquid.
Do not use abrasive scouring pads, powders or cleaners. Use a moisture-proof sponge to
scrub the dirt.
After each use, clean all the detachable parts in water and dry them thoroughly.
Note: The removable water tank cannot be washed in the dishwasher.
Use the provided accessory to clean the steam conduct after each use, to eliminate any
residues.
5. TROUBLESHOOTING
Problem
Cause
Solution
Nothing is displayed in
the screen.
Check if the device is plugged
in.
Plug the device in and make
sure it is turned on.
The indicator light on the
device’s front panel is red.
The coffee bean tank is not
correctly fixed into placed.
Assemble it correctly.
Water stains can be
found on the bottom of
the machine.
The water tank or the
cup-holder tray are not fixed
into place or are full.
Make sure the water tank and
the cup-holder tray are fixed
into place. In case they are
correctly fixed into place and
the cup-holder tray is empty
and the problem is still not
solved, send the device to be
repaired. Do not try to repair
it yourself.
The device emits a ticking
sound when turned
on and a hiss when
dispensing coffee.
This is perfectly normal.
This sound is produced by
a correct operation of the
control valve.
The funnel does not
dispense coffee or
dispense it drop by drop.
Too much coffee powder or
too fine.
The amount of coffee powder
should not exceed the limit.
Change the coffee bean’s
setting to a correct value. Do
not try to press the coffee
powder with excessive force.
Coffee comes out without
froth and watery.
Coffee beans are damp or too
coarse.
Use fresh coffee beans and a
moderate amount of coffee
powder.
No steam comes out the
device.
The steam nozzle is blocked
or the device has not been
pre-heated.
The device will only emit
steam after it has been
pre-heated. The device needs
to be descaled. Clean the
steam nozzle with a cleaning
needle.
After steam is released,
the device does not allow
you to make coffee and
it starts to pump water
automatically.
After dispensing steam,
the device needs to release
pressure and lower its
temperature. While this
is being done, no other
operations can be performed.
It takes 20-30 s to release
the pressure and reduce the
temperature. After this, the
indicator on the control panel
will return to normal and you
can brew coffee again.
6. TECHNICAL SPECIFICATIONS
Reference number: 01589
Product: Cumbia Power Espresso 20 Barista Cream
Rated Power (coffee): 1380-1550 W
Rated Power (steam): 150 W
220-240 V~, 50/60 Hz
