47
46
ENGLISH
ENGLISH
spiral motion at maximum power. Then, it will return directly to the charging base.
It can only be activated from the App.
Scrubbing mode: When this mode is activated, the robot moves in a swaying motion,
simulating real scrubbing moves. It starts off cleaning in Edge mode, then in zigzag motion
and finally returns to the charging base taking the straightest way back home.
It can only be activated from the App.
Manual mode: To carry out manual cleaning, use the direction buttons on the remote control
or on the App to take the robot to the specific points where you want it to clean.
It can be activated from the App or the remote control.
Back home mode: Select this mode at any point of any cleaning cycle and during any of the
modes, the robot will automatically return to the charging base.
It can be activated from the robot, the remote control or the App.
Smart Area mode: Once the home’s map has been saved, select this mode for the robot to
clean a specific area in zigzag motion. The robot will clean the selected area and then will
return directly to the charging base. You can set more than 1 area at the same time. The robot
will only clean the area selected in the map; therefore it will go to the point and return to the
base without vacuuming.
It can only be activated from the App.
Spot mode: Select this mode if you want to clean thoroughly a specific point in the map,
making the most of the robot’s maximum power. The robot will clean a 2x2 m zone in zigzag
motion and then will return directly to the charging base when cleaning is completed. The
robot will only clean the area selected on the map; therefore it will go to the point and return
to the base without vacuuming.
It can only be activated from the App.
Restricted Area mode: Select this mode and delimit in the map specific areas where you do
not want the robot to clean. You can set more than 1 restricted area at the same time on the
map.
It can only be activated from the App.
Twice mode: Use this mode to carry out a deep, thorough cleaning of your home.
It can be combined with Edge, Spiral, Spot or Smart Area modes. The robot will carry out 2 full
cleaning cycles and then will return directly to the charging base.
Final cleaning
Before returning to the charging base, the robot moves forward and backward several times
in order to eliminate any rests of dust from the brush.
6. CLEANING AND MAINTENANCE
Main brush
Turn the robot around and press the main brush’s release button to take the cover out.
Take the main brush out and clean the compartment.
Clean the main brush with the provided tools and use water and soap if necessary.
Place the main brush in its position and fasten the cover’s clip.
Recommendation: Replace the main brush every 6-12 months to ensure efficient operating
(depending on the frequency and type of use).
Fig.25.
Main brush cover
Tab
Main brush
Compartment
Silicone brush
Fig.26.
To clean the silicone brush, follow the instructions on the previous section to remove it from
the robot and wash it with water and soap. Dry it thoroughly before assembling it back in
order to ensure efficient operation.
Jalisco brush
Fig.27.
To clean the Jalisco brush, follow the previous section’s steps to take it out and clean it with
water. Dry it thoroughly before assembling it back in order to ensure efficient operation.
Dust tank
Fig.28.
Take the dust tank out.
Open the dust tank cover and empty it.
Use the cleaning brush to clean the inside of the dust tank.
Install the dust tank back in the robot.
Wet & dry tank
Fig.29.
Take the Wet & dry tank out.
Detach the dust compartment from the rest of the tank.
Open dust compartment and empty it.
Use the cleaning brush to clean the dust compartment.
Summary of Contents for CONGA 6090 ULTA
Page 82: ...161 160...
Page 83: ...163 162 2 3 4 1...
Page 84: ...165 164 5 1 2 3 4 6 7...
Page 85: ...167 166...
