![cecotec BOLERO DRESSCODE 10400 INVERTER Instruction Manual Download Page 24](http://html.mh-extra.com/html/cecotec/bolero-dresscode-10400-inverter/bolero-dresscode-10400-inverter_instruction-manual_2578605024.webp)
47
46
ENGLISH
ENGLISH
BOLERO DRESSCODE_8400 INVERTER / 9400 INVERTER / 10400 INVERTER
QuickStart
Before washing
Plug the device into a power supply.
Open the tap.
Load.
Close the door.
Add detergent.
Fig. 13.
Note: Detergent must be added in "case I“ only after selecting pre-washing for machines with
this function.
Washing
Turn the device on.
Turn the knob to select the desired programme.
Select function or use the default one.
Press Start.
Fig. 14.
Note: If any of the default options is selected, step 3 can be skipped.
After washing
The appliance will beep, or the display will show “End”.
Using the washing machine
Before each washing
The washing machine should be operated within a temperature range of 0-40 °C. If used under
0°C, the inlet valve and draining system may be damaged. If the machine is placed or operated
in rooms at 0 °C or below, it should be transferred to normal ambient temperature to ensure
the water supply hose and drain hose are not frozen before use.
Check the labels and the product instructions when using detergent before washing. Use
non-foaming or less-foaming detergent suitable for machine washing.
Check the label. Fig. 15.
Empty the pockets of the clothes to be washed. Fig. 16.
Knot the long strips, close zips or tighten button. Fig. 17.
Put small clothes inside a pillow slip. Fig. 18.
Turn easy-pilling and long-pile fabrics inside out. Fig. 19.
Separate clothes with different textures. Fig. 20.
Loosen the clamp nut and four bolts.
Tighten the clamp nut.
Press slide bushing and insert inlet hose into connecting base.
Connection finished.
Connection between screw tap and inlet hose. Fig. 9.
Tap with threads and inlet hose.
Special tap for washing machine.
Connect the other end of inlet hose to the inlet valve at the backside of product and fasten the
pipe tightly clockwise. Fig. 10.
Drain hose
Note: Do not kink or protract the drain hose.
Position the drain hose properly, at 60-90 cm from the floor.
There are two ways to place the end of the drain hose:
In a drainpipe. It is recommended to use a vertical tube.
In a sink’s drainpipe, over the trap.
Fig. 11
If the machine has drain hose support, it can also be installed on a sink or a tank, like the
following. Fig. 12.
Warning: When installing drain hose, fix it properly with a rope. If drain hose is too long, do not
force it into washing machine as it will cause abnormal noises.
4. OPERATION
Note:
Please make sure the appliance is properly installed before operating it.
Before washing the clothes for the first time, the product shall be operated in one round of the
whole procedures without the clothes inside.
It is recommended to calibrate the appliance in order to ensure optimum operation:
Empty the washing machine.
Plug it in.
Turn the appliance on and press Speed and Delay at the same time within 10 seconds. The
display will show “t19”.
Press the Start/Pause button. The display will show “****” and the calibration process will
begin.