cecotec 05548, Instruction Manual

Page: 25 / 34

25
ENGLISH
3
. BEFORE USE
Take all pieces out of the packaging.
Unfold the main body.
Insert the suction head into the lower end of the main body. Make sure it is fastened firmly.
To remove the head from the main body, press the suction head lock/release button and pull
it out.
There is a lock on the bottom of the suction head to fix the Multipurpose brush.
Check for any visible damage, if any is observed, contact as soon as possible the Technical
Support Service of Cecotec for advice or reparation.
Fig. 4
4
. BATTERY CHARGING
Warning: Use only the charger supplied with the appliance. All repairs or battery
replacementsmust be performed by an authorised technical support service. It is important to
charge the batteries completely before using the appliance for the first time. The first charge
will take approximately 3 hours.
Attach the charging support piece to the charging support base.
Hang the appliance on the hook of the charging base. Make sure that the appliance sits properly
on the base.
Plug the charger to the charging base. Then, plug the adapter to the mains supply.
Charge the batteries at room temperature between 4 and 40 ºC.
The pilot light will blink while charging to indicate that the charger is working. When the
appliance is fully charged, the charger will switch off automatically and the pilot light will stop
blinking and remain on.
After charging, unplug the charger from the mains supply and the charging base. Do not use the
appliance while connected to the charger. Store the charger in a safe place for future charges.
The appliance is now ready for use.
Note:
Do not store or charge the appliance near heat sources, nor expose it to direct sunlight.
Do not charge the appliance in dirty or wet places.
Fig. 5
5
. OPERATION
Press the on/off button on the handle to turn the appliance on. Both the LED lights on
the suction head and the pilot lights on the handheld vacuum cleaner will light up with