cecotec 05425, Instruction Manual

Page: 25 / 79

47 46
7090 7090
ENGLISH ENGLISH
Final cleaning
Before returning to the charging base, the robot moves forward and backward several times
in order to eliminate any rests of dust from the brush.
6. CLEANING AND MAINTENANCE
Main brush
Turn the robot around and press the main brush’s release button to take the cover out.
Take the main brush out and clean the compartment.
Clean the main brush with the provided tools and use water and soap if necessary.
Place the main brush in its position and fasten the cover’s clip.
Recommendation: Replace the main brush every 6-12 months to ensure efficient operating
(depending on the frequency and type of use).
Fig. 25.
Main brush cover
Tab
Main brush
Compartment
Silicone brush
Fig. 26.
To clean the silicone brush, follow the instructions on the previous section to remove it from
the robot and wash it with water and soap. Dry it thoroughly before assembling it back in
order to ensure efficient operation.
Jalisco brush
Fig. 27.
To clean the Jalisco brush, follow the previous section’s steps to take it out and clean it with
water. Dry it thoroughly before assembling it back in order to ensure efficient operation.
Dust tank
Fig. 28.
Take the dust tank out.
Open the dust tank cover and empty it.
Use the cleaning brush to clean the inside of the dust tank.
Install the dust tank back in the robot.
Wet&Dry tank
Fig. 29.
Take the Wet & dry tank out.
Detach the dust compartment from the rest of the tank.
Open dust compartment and empty it.
Use the cleaning brush to clean the dust compartment.
Assemble the dust compartment in the Wet & dry tank.
Install the Wet & dry tank back in the robot.
If the Scrubbing mode has been used, empty the water tank and then fill it with clean water to
rinse it. Empty it again before installing it back in the robot.
High-efficiency filter
Fig. 30.
Remove the high-efficiency filter and shake it to remove all the dust.
Note:
Replace the high-efficiency filter every 3 months depending on the frequency and type of use.
Clean the filter periodically with a brush to avoid blockage. Do not use water or detergents.
Side brush
Fig. 31.
Remove and clean the side brushes regularly.
Recommendation: In order to ensure a perfect cleaning, it is suggested to replace the side
brushes every 3 months, depending on the frequency and type of use.
Free-fall sensors
Fig. 32.
Clean the free-fall sensors with a soft cloth regularly.
Warning: Always transport the product turned off and in its original package.
Visual detection sensor
Fig. 33
Clean the lens with a soft, clean cloth. Avoid using detergents or sprays during clean-ups.
7. BATTERY REPLACEMENT AND CHARGING
Do not use any other battery, power adapter or charging base than the one officially provided
by Cecotec.
Do not use non-rechargeable batteries.
Do not remove, dismantle or attempt to repair the battery or the charging base.
Do not place the charging base near heat sources.