Cecilware VENEZIA II HC-600, Instruction Manual, Page: 4 / 10

4
4) Unpacking and Installation
Warning: All appliances’ technical handling operations such as installation, maintenance, or service
should be performed by certified personnel or by your local dealer.
• After opening the box, make sure that the appliance is intact and that there is no visible damage. If there is
any doubt, DO NOT use the appliance and call your local dealer for further assistance.
• Unpack both boxes carefully. For your convenience we suggest storing all packaging materials where they
can be used in the future, whenever the appliance’s transportation is necessary.
• Place the grinder on a stable flat counter in a dry area away from water or water splashes.
• Position the coffee residue tray underneath the body in front of the appliance.
• Install the bean hopper firmly on top of the body inside the top blade holder.
• Fasten the hopper to the appliance body by means of the supplied screw.(fig. 4.1) Make sure that the screw is
inserted completely through both holes in the hopper and in the top blade holder.
• NEVER OPERATE THE GRINDER IF THE BEAN HOPPER IS NOT FULLY SECURED IN ITS POSITION.
• Before plugging in the electrical cord, make sure:
o The appliance voltage and frequency rating (according to the back side label) is the same as the supply
mains.
o The wall socket is fitted with an efficient ground contact. DO NOT plug the appliance into the supply
mains if the ground system was not positively checked to be in compliance with current safety rules. IT
IS COMPULSORY TO GROUND THE APPLIANCE. The manufacturer cannot be held responsible in the
event that this regulation is not complied with.
o The power consumption of the appliance (according to the back side label) is consistent with the
relevant wall socket capacity.
o The wall socket is protected against short-outs and power surges.
o Do not use extension cables, plug adapters for multiple sockets, or makeshift connections.
• Plug in the appliance.
• Upon first time operation, and before placing beans into the hopper, VISUALLY check that the blade rotation
direction is clockwise by switching the appliance ON for a few seconds.
• Should the rotation direction be wrong, do not use the appliance and contact your local dealer for further
instructions.
5) Operation
Switching ON and OFF
• The appliance is equipped with a 5 minute timer.
• Switch ON the appliance by turning the timer knob clockwise to the desired time of operation.
• The appliance will switch OFF automatically when the preset time is over or it can be switched OFF manually
by turning the timer knob all the way counterclockwise.
!
Figure 4.1