CHAPTER 5 - APPENDIX
REMOTE CONTROL KEY FUNCTIONS
Detailed View
The images below depict the standard HD-300ZX device showing the
front view with its connections and the rear view with the LED lights.
Front View
1. ON/OFF switch
2. Power receptacle
3. A/V multi connector
4. SPDIF audio output
5. USB ports
6. Ethernet RJ-45 port
7. 802.11b/g antenna
Rear View
1. CF card slot
2. LAN Access LED
3. Infrared Receiver
4. Power LED
Note: These images are for reference only. Your model may come in a
different color and with the 802.11b/g antenna installed already.
FAQ
If your display is blank and you can not see the HD-300ZX menu, press the TV
Mode button on your remote control to toggle between the different video
outputs. Once you can see the main screen, go to the setup menu, select
the Audio Video tab and set the correct tv / monitor type and resolution.
Next press the SETUP button to save your video output settings.
Q: I’ve modified some of the settings but there seems to be no change!
A: Make sure you have saved the new settings by pressing the SETUP button.
Next, restart the unit by turning off the power switch. Turn it back on a few
seconds later.
Q: Why are some of the functions in this manual not the same as on my
HD-300ZX?
A: The functions may change with every firmware update. Please contact CE
Labs for information about downloading the latest manual and firmware from
our website.
Q: Can I turn off the messages like “Loading File” as an example?
A: Yes, you can turn off the on-screen messages in the setup menu. Go to the
MISC2 category and turn off the OSD messages.
Q: I’ve enabled the Manual/Standby Play Mode and now it shows “NO TITLE
FILES”!
A: This message will appear if there is no 000.avi or 000.jpg & 000.mp3 file on
the local drive. It will also appear if a numeric button is pressed but there is no
such a file. Make sure to rename your files properly and store them on the
local drive, then try again.
A free 15 day trial of Quicksign 300 is available at
http://www.celabs.net/sw/qs300/
