EN
EN
SOLAR2R
Standalone proximity keypad
5
cdvigroup.com
6] READER CONFIGURATION AND RESETTING THE CONTROLLER
3. Complementary information :
- Green LED flashes on the controller indicate that the connection between the reader
and controller is good.
- The tamper switch activates the relay of the alarm when the keypad is removed. Both
readers are locked out. The red LED lights turns on with a permanent beep during the
time of the lockout.
- The EEPROM memory can be used to restore the memory in case of the product
substitution.
1. Reader configuration :
- On the readers make sure both dipswitches are
positioned to off.
1 reader configuration :
- Press
1B
, the reader turns blue and position both dipswitches on the reader to ON.
2 readers configuration :
- Press
1B
on the reader 1 and then
2B
on the reader 2, then position the dipswitches n°2
of both the readers to ON. On the reader that ends the RS485 link, position the dipswitch
n°1 to ON.
2. Controller reset :
To FACTORY RESET the controller:
On the central bord, position dipswitch
1
to ON :
static green LED,
red LED + green LED.
Position dipswitch
1
to OFF : green LED flash.
To reset MASTER CODE :
Position dipswitch
2
to ON : static red LED .
Position dipswitch
2
to OFF : green LED flash.
ON
ON
ON
OFF
1
2
ON
ON
ON
OFF
1
2
ON
ON
ON
OFF
1
2
ON
ON
ON
OFF
1
2
ON
ON
ON
OFF
1
2
ON
ON
ON
OFF
1
2
ON
ON
ON
OFF
1
2
Don’t forget to connect the door contacts