Copyright All Rights Reserved ROFU Security International Corp. ROFU BKC-5000B. Published: February 12, 2020
BKC-5000B Pre-Installation
LED & Audible Indicators
BKC-5000B Wiring Diagram
2
Parts List:
Flat head phillips screws,
Cone point
Three-point screwdriver
(special tool)
Anchor bolts x4
Proximity key fob x1
Proximity EM cards x2
Crimp connectors x12
Three-point security screw x1
x4
x1
(BKC-5000B have same wiring and pin setting)
Power on, Standby mode
Unlocked, Door always unlocked
Invalid access, Door always locked
Blue
Green
Red
1 Short beep
1 Long beep
2 Short beeps
3 Short beeps
Constant beeping
Key press
Valid access, Reset is completed
Login completed
Invalid access, Forget to press #
after entering passcode within
30 seconds
Bluetooth device vandalized,
Door sensor is on
LED
Status
Audible Beeps
Status
Reset Procedures
1. Power off Access Control Reader.
2. Move the Pin Jumper to P2 and P3, then power on.
3. Hear a long beep to complete resetting procedures.
4. Move the Pin Jumper back to P1 and P2 to Normal setting.
5. Login as Admin and check all users, audit trail events are all cleared and everything is reset to
factory default setting, except device name.
RTE (Request-To-Exit)
RTE (Request-To-Exit)
DS (Door Sensor)
DS (Door Sensor)
NC (Fail-Safe Electrified Lock)
COM
NO (Fail-Secure Electrified Lock)
V- (Power Supply)
V+ (Power Supply)
ALM (Alarm Output)
ALM (Alarm Output)
(Polarity
Insensitive)
Green
Green
Brown
Brown
Yellow
White
Blue
Black
Red
Orange
Orange
Cable
Normal
Buzzer
Jumper Pin Setting:
Reset
(Default)
