4
5
EN
EN
CZ3000
Self-aligning Magnetic Shearlock
+
_
NC
CO
MN
O
12VDC
24VDC
(x2)
1
2
(x8)
3
(x2)
1
2
(x8)
1
(x2)
1
2
(x8)
2
5] WIRING DIAGRAM
* Input voltage: 12 VDC or 24 VDC
The magnet can be powered in 12 VDC
or in 24 VDC according to the jumper
settings.
Terminal block
+
Input voltage 12 V or 24 VDC*
-
Input voltage 12 V or 24VDC*
NC
Normally closed contact
C
Common
NO
Normally open contact
C - Surface mount (Optional: KCZ3000 kit)
Fix the magnet on the door and
place the housings.
Measure and mark the center
lines to determine the magnet
position on the jamb and the
armature plate on the door
leaf frame. Then drill the fixing
screw holes to fix the screws
easily.
Important: The surface hou-
sing can be mounted in horizon-
tal or in vertical in the secure
side.
Mount the brackets of the housing
on the jamb and on the door leaf.
Insert the cable and temporarily
fix the magnet and the armature
plate to the bracket of the hou-
sing. Loosen the screws on the
side of the armature plate (1) with
the Allen key. Then adjust the
gap between the magnet and the
armature plate by adjusting the
top screws on the armature, allow
2mm distance maximum. Tighten
the 2 screws on the side of the ar-
mature plate (2) once the test on
the magnet has been successfull.
