2
3
EN
EN
CZ3000
Self-aligning Magnetic Shearlock
1
2
3
A - Wooden door
1
2
1
1
2
(x8)
3
1
2
(x8)
1
1
2
(x8)
2
1
2
2
4] MOUNTING INSTRUCTIONS
Make sure that there are no pieces missing in the mounting kit. Use the correct
tools according to the installation type (Drill, screw drivers, metre tape,...) and
follow the mounting instructions of the CZ3000.
Test the functioning of the ar-
mature plate and the back plate,
then fix the magnet to the door
(note that the mounting screws
are not included).
A - Wooden door
B - Aluminium door
Cut the holes on the door leaf
and on the door jamb in order
to insert the magnet and the ar-
mature plate of the CZ3000 ma-
gnet. Then mark the mounting
holes of the mounting screws.
Drill the mounting holes of the
magnet and of the armature
plate in order to fix with the
supplied screws. Drill the cable
access hole.
Place the magnet on the back
plate of the surface housing
as well as the armature on the
second back plate of the surface
housing and fix the magnet on
the door.
Cut the holes on the door leaf
and on the door jamb in order to
insert the magnet and the arma-
ture plate of the CZ3000 magnet.
Then mark the mounting holes
of the mounting screws and
drill the mounting holes of the
magnet and of the armature
plate in order to fix with the
supplied screws.
Mount the back plate of the hou-
sing (note that the screws are not
included). Loosen the screws on
the side of the armature plate (1)
with the Allen key. Temporarily
mount the CZ3000. Then adjust
the gap between the magnet and
the armature plate by adjusting
the top screws on the armature,
allow 2mm distance maximum.
Tighten the 2 screws on the side
of the armature plate (2) once the
test on the magnet has been suc-
cessful.
Insert the cable of the magnet.
Loosen the screws on the side of
the armature plate (1) with the
Allen key. Temporarily mount
the CZ3000. Then adjust the gap
between the magnet and the
armature plate by adjusting the
top screws on the armature, allow
2mm distance maximum. Tighten
the 2 screws on the side of the
armature plate (2) once the test on
the magnet has been successful.
