17
Installation
•
Do not install this appliance if it is damaged in any way. Installing a
damaged appliance may invalidate the warranty.
•
The water supply tap should be located in an adjacent cupboard so that it
can be accessed after installation.
•
Ensure the appliance is level by adjusting the feet as necessary. The
dishwasher is equipped with an adjustable rear foot that can be raised or
lowered by means of an adjustment screw, located in the centre of the
kick plate.
•
Only use the water inlet supplied with the appliance.
•
If the water pressure is above 10 bar, a pressure relief valve should
be used.
•
After connecting the water supply, check to ensure there are no leaks.
•
The water outlet can either be connected to a water drain or to a sink
outlet spigot. This connection should be at a minimum of 50 cm and a
maximum of 110 cm from the floor. The drain hose should be no longer
than 4m in length to ensure good performance from the dishwasher.
•
To prevent siphoning, ensure that the water outlet is not pushed too far
into the waste standpipe. The lowest part of the water outlet should be
level with the bottom basket of the dishwasher.
•
When connecting to the sink, ensure that the waste pipe runs higher
than the level of the sink bowl to prevent siphoning.
fig. 22
fig. 20
fig. 21
Summary of Contents for WC461
Page 19: ...19 ...
