21
•
If an oven is to be installed below the hob, the thermal safety
system on the hob will not allow the hob to be used at the same
time as a pyrolytic programme on the oven.
•
The hob is equipped with an anti-overheating safety device that
can be activated if the hob is installed over an oven that is not
sufficiently ventilated. In the event that this occurs, the zone display
will show
C
. We recommend that you increase the ventilation of the
hob by creating an opening in the side of the cabinet (8 cm x 5 cm).
How to install the hob:
Overall dimensions of the hob:
HVN61FR:
Width: 580 mm
Depth: 510 mm
HVN81FR:
Width: 770 mm
Depth: 510 mm
Worktop cut-out dimensions:
HVN61FR:
Width: 560 mm
Depth: 490 mm
HVN81FR:
Width: 750 mm
Depth: 490 mm
1. Make the required hole in the work-
top. Before doing this, you must
check the instructions supplied with
any cooker hood to ensure that you
will have the required clearance. The
cut-out (Fig.6) shows a 60mm gap
Fig.4
Hob
Top rail removed to allow air to exit.
Recommended 560mm x 6mm
Air intake into the run of units.
Recommended 560mm x 10mm
A ventilation slot may need to be cut
into the base if there is no ventilation
provided.
Recommended 560mm x 25mm