CDA HVG95, Manual For Installation, Use And Maintenance

Page: 26 / 36

26
CONNECTION TO THE GAS SUPPLY
✓
Be careful when flexible pipes are used that they do not come into contact with
moving parts.
✓
To maintain the thickness of 3 cm, the hob is fitted with a channel to contain the
connection pipe.
✓
The gas inlet union can be turned in the direction required after the elbow fitting
“
C ” and nut “ A ” connection (figure 23) has been slackened (Fig. 24).
✓
Never put it in the horizontal or vertical position.
✓
Never attempt to turn the elbow “ C ” without having first slackened off the relative
lock
nut
“ A ”.
✓
The gasket “ F ” (fig. 23) guarantees the seal of the gas connection.
It is recommended that it be replaced whenever it shows even the slightest
deformation or imperfection.
✓
Using a suitable leak detection fluid solution (e.g. Rocol) check each gas
connection one at a time by brushing the solution over the connection.
The presence of bubbles will indicate a leak. If there is a leak, tighten
the fitting and then recheck for leaks.
IMPORTANT! Do not use a naked flame to test for leaks
Figure 24 Figure 23
1/2" G co n ic al
(ISO 7-1) mal e
1/2" G cy l i ndr ic al
(ISO 22 8 -1) mal e
1/2" G cy l i ndr ic al
(ISO 22 8 -1) fe mal e
C F A
GAS CONNECTOR
Cat: II 2H3+
The fitting (fig. 23) is made up of:
✓
1 nut “ A ”
✓
1 elbow fitting “ C ”
✓
gasket “ F ”
GB