17
How to Install the Hob
How to install the hob:
Overall hob dimensions:
HVG621 = 595mm (W) x 515mm (D)
HVG721 = 700mm (W) x 515mm (D)
Worktop cut-out dimensions:
557mm (W) x 477mm (D)
1. Make the required hole in the worktop. Note that before doing this,
check the instructions supplied with any cooker hood to ensure that
you will have the required clearance. The hob cut-out (Fig 6) shows
a minimum 50mm gap from the rear wall or splashback to the cut-
out edge.
2. Position the hob seal, as shown in the diagram below (Fig 8),
ensuring that the ends meet without overlapping. Do not use
silicone type sealant.
3. Secure the hob to the worktop using the fixing brackets and screws
supplied, as shown in the following diagram (Fig 9).
Remove any excess sealant after tightening the brackets.
Fig.6
Fig.7
Fig.8
Fig.9
185mm
185mm
>50mm
560cm
150mm
150mm
557mm
477mm
3cm
4cm
700mm
400mm
